blank blank ubnt ubnt admin … Enter the IP of the antenna of choice into my web browser. February 25, 2015 December 24, 2018 Stories for Kids internet, internet bridge, m2, m5, nanostation, satellite, set up, through trees, ubiquiti, wireless bridge. Not bad considering I’m going through some trees. *There is also now a 2 pack available which is supposedly already configured to make it easier to set up. Access Point: This is the antenna that gets plugged into the internet source that you are sharing. https://amzn.to/2LmMKTo, I personally just went with a cheap cat5e cable. Some computers were having issues connecting to the internet there. Make sure that your host system is connected via Ethernet to the device. The ETH-SP will absorb power surges and safely discharge them into the ground. Keep reading. “Access Point: This is the antenna that gets plugged into the internet source that you are sharing. Shielded Category 5 (or above) cabling with drain wire should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE. 24 V, 0,5 A PoE-Adapter (im Lieferumfang enthalten), Passiver PoE (Paar 4, 5+, 7, 8 Rückfluss), Compliance-Verantwortlichkeit des Installateurs. Für Installationen in Außenbereichen muss Überspannungsschutz verwendet werden. ( Log Out /  I no longer live there, so can’t comment on durability over a long period of time. 5. Configure the Ethernet adapter on your host system with a static IP address on the 192.168.1.x subnet. Wenn Sie das Gerät auf die Werkseinstellungen zurücksetzen möchten, drücken Sie die Reset-Taste länger als 10 Sekunden, während das Gerät eingeschaltet ist. Surge protection should be used for all outdoor installations. Recently, I purchased two Ubiquiti Nanostation M2’s to beam internet from my workplace to my home. Others IP addresses used by the router brand Ubiquiti. ( Log Out /  Director,Procurement (NanoStation M2/M3/M5 only) The LED will light steady green when an active Ethernet connection is made to the Secondary port and flash when there is activity. At work, the internet clocks at around 36mbps download, at home I’m getting around 22mbps up. I know I can get through about 7 tree tops and still get a pretty solid signal. Give your router an IP that isn’t used by anything else. Die Felder Output Power (Ausgangsleistung) und Antenna Gain (Antennenverstärkung) erleichtern dem professionellen Installateur die Einhaltung gesetzlicher Vorschriften. I got a ton out of this video, and basically did what he said, but there was one big thing missing from the demonstration that caused me a lot of frustration. NSM2/NSM3/NSM365 Operating Frequency (MHz). To connect to the internet, you will need DHCP enabled. They do not come in pairs (at the time of the original post). A quick search will help you here. To login with the modem Ubiquiti NanoStation-M5 you will need to use the following default username and password: ubnt/ubnt. To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. Die LED leuchtet grün, wenn eine aktive Ethernet-Verbindung mit dem Main/LAN-Port besteht, und blinkt bei Aktivität. Press and hold any of these to set your Nano’s settings to factory default and then you can reconfigure it. Change ), You are commenting using your Facebook account. What do I do now? Konfigurieren Sie den Ethernet-Adapter auf Ihrem Hostsystem mit einer statischen IP-Adresse im Subnetz 192.168.1.x. Die Geräte müssen professionell installiert werden und es liegt in der Verantwortung des professionellen Installateurs, sicherzustellen, dass das Gerät innerhalb der landesspezifischen Vorschriften betrieben wird. Devices must be professionally installed and it is the professional installer’s responsibility to make sure the device is operated within local country regulatory requirements. Right now it's winter so there aren't leaves on the trees, but for the month or so I've… https://papermovementblog.wordpress.com/2015/02/25/how-to-setting-upconfigure-the-ubiquiti-nanostati… […]. For my Station Point (my house) it’s 192.168.1.160. Wir empfehlen Ihnen, Ihre Netzwerke mit dem abgeschirmten Ethernet-Kabel von Ubiquiti in Industriequalität vor schädlichen Außenumgebungen und destruktiven Entladungen zu schützen. I have not had to tinker with settings, reboot the router to reconnect, it doesn’t drop the connection, it doesn’t lag  etc. The information is available online, I just couldn’t find everything I needed in one place so i thought I’d try to compile some of the more important/difficult-to-find things that I learned right here. It exceeded my expectations. The Antenna Gain and Output Power fields are provided to the professional installer to assist in meeting regulatory requirements. Die ETH-SP absorbieren Überspannung und leiten sie sicher in den Boden ab. It did the job just fine. Hopefully this helps some people, use the comments for any other set up tips you may have. Create a free website or blog at WordPress.com. My router at home was conflicting with my work’s router (the access point). You need to change your internet settings to setup/tweak the antennas.